 retapping/cleaning port holes in intake |
  |
 Jul 28 2010, 07:56 AM
Post
#1
|
|
|
Member  Group: Members Posts: 11 Joined: 23-March 10 Member No.: 8,558  |
i pulled my injector bodies out of intake to send to spud to be flowed..when i did this i noticed that a few of them the threads looked bad...i already have intake and blower bolted on engine..can i run a tap into intake and clean up holes before i attemp to reinstall injector bodies without taking blower and intake off engine or will the cleaning threads put to much aluminum shavings into engine and hurt it?
thanks don badtoyzz racing 775-340-5505 -------------------- [size="5"][/size]BADTOYZZ RACING
|
 |
 
|
|
Jul 28 2010, 04:43 PM
Post
#2
|
|
 Advanced Member Group: Members Posts: 219 Joined: 13-September 08 From: Jensen Beach, Fl Member No.: 79 |
If you put grease on the tap that will minimize any debris that falls into the intake. I would ordinarilly advise using a tread chaser rather than a tap in aluminum but your only choice is a tap for NPT.
Frank |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 5th September 2010 - 06:03 AM |
Powered By IP.Board
2.3.5 © 2010 IPS, Inc.